Kelayakan Komposit Pet Daur Ulang Berpenguat Talc Resin Sebagai Bahan Filamen 3D
DOI:
https://doi.org/10.33504/jitt.v4i1.376Keywords:
Impact test, Mechanical strength, Plastic waste, 3D filament, Talc resinAbstract
This study aims to utilize used PET plastic waste as a basic material for 3D filaments with the addition of talc resin as a reinforcing material. Literature review shows that talc resin can increase stiffness and mechanical strength in polymer composites. The experimental process was carried out through mixing, molding, and tensile and impact tests according to ASTM standards. The test results showed that the addition of 10% talc resin provided optimal tensile strength and toughness compared to other varia tions. Thus, filaments based on used plastic and talc resin are suitable for use in environmentally friendly 3D printing applications.
Downloads
References
Baedowy, I. R., Supriyatin, T., & Damayanti, S. (2020). Pengelolaan sampah plastik sebagai solusi lingkungan. Jurnal Lingkungan Hidup, 12(1), 45–53.
De Jong, J., & Mellquist, R. (2021). Plastics and the environment: Challenges and solutions. Environmental Technology Review, 13(4), 143–159.
Diana, N., Safitra, H., & Ariansyah, M. (2020). Studi karakteristik komposit berbasis serat alam dan matriks polimer. Jurnal Material Teknik, 8(2), 112–121.
Maghfira, A. (2022). Pengaruh talc resin terhadap sifat mekanik komposit polimer daur ulang. Jurnal Teknologi Polimer, 9(1), 34–41.
Mardiyati, Y. (2018). Komposit polimer dan aplikasinya. Bandung: UPI Press. Murathee, S., Wijaya, R., & Nuraini, D. (2022). Analisis karakteristik limbah plastik sebagai bahan baku daur ulang. Jurnal Teknik Lingkungan, 6(3), 79–86.
Sari, N., Aisyah, R., & Rahayu, P. (2023). Potensi pemanfaatan botol plastik bekas sebagai material alternatif dalam teknologi. Jurnal Inovasi Material, 5(1), 22–29.
Singh, A., Patel, K., & Kumar, R. (2022). Development of recycled plastic-based filaments for 3D printing. International Journal of Polymer Science, 2022, Article ID 783451.
Suci, R., Janiroh, N., & Tohari, M. (2021). Pengaruh jenis plastik terhadap karakteristik cetak 3D. Jurnal Teknologi Manufaktur, 7(2), 98–105.
. Edi W, Iswanto. (2022). Mekanika Komposit dan Bio-Komposit. UMSIDA PRESS.
. Raliannoor, A’yan Sabitah. (2020). Pengaruh Kekuatan Impak Poliester Berpenguat Serat Bambu Haur Dan Fiberglass Pada Aplikasi Bumper Mobil. Elemen:Jurnal Teknik Mesin,7(1), 28-37.
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2026 Jurnal Inovasi Teknologi Terapan
This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.
